Valtra A95l Manual do Operador

--- 6 3 ---G. Maintenance scheduleG. Maintenance scheduleG1. ServiceCorrect maintenance at the right time is a basic conditionfor reliable operation o

--- 7 2 ---H. Periodic maintenanceH3.3. Lubrication of the three---point linkage (5)65--- 611122334 4Use Valtra Universal Grease.--- 1, the top link,

--- 7 3 ---H. Periodic maintenance--- Adjust through the adjusting rod (B ) of the adjustmentbelt pulley--- Tighten the adjustment belt pulleyH 3.5.3.

--- 7 4 ---H. Periodic maintenanceIMPORTANT: In winter it is very important to allow theengine to run for a little while after topping up with distill

--- 7 5 ---H. Periodic maintenanceH4. Maintenance every 500 hoursH4.1. Clean cab air filter and alsoupper filter (extra equipment) (11)Clean lower fil

--- 7 6 ---H. Periodic maintenanceH4.3. Check wheel nuts (13)NOTE: Check torque of wheel nuts (also rim/wheel discs)frequently (values are listed in t

--- 7 7 ---H. Periodic maintenanceH4.6. Change engine oil and engineoilfilter (16)In extremely dusty conditions or when using over 5 %Biodiesel fuel,

--- 7 8 ---H. Periodic maintenanceH4.8. Check pedal free travel ofpropulsion clutch (18)A3565--- 10420---25 mmSlowly press down the clutch pedal until

--- 7 9 ---H. Periodic maintenanceH 4.12. Checkoillevelinhubreduc-tion gears, 4---wheel drive (22)A3565--- 108Turn the wheel until the oil surface ind

--- 8 0 ---H. Periodic maintenanceH5. Maintenance every 1000 hours or yearlyH5.1. Change oil and oil breatherfilter in hydraulic system (26)Draining65

--- 8 1 ---H. Periodic maintenanceH5.3. Change oil in differential,4 --- w h e e l d r i v e ( 2 8 )A3565--- 114213Remove the drain plug (1). Clean th

--- 6 4 ---G. Maintenance scheduleG2. Recommended fuel and lubricantsAll volumes are with filters.Part of machine Valtra---grade SAE/ViscocityA P I --

--- 8 2 ---H. Periodic maintenanceH5.6. Cleanfueltank(31)Always clean the fuel tank at the start of the winterseason. This avoids problems with conden

--- 8 3 ---H. Periodic maintenanceFilters fitting13AH30--- Check that, the seals are in good condition--- Check that, the sealing surfaces are clean--

--- 8 4 ---H. Periodic maintenanceH 5.11. Check and adjust valve clea-rance (36)A3565--- 120Both inlet and exhaust valves should have a valveclearance

--- 8 5 ---H. Periodic maintenanceH6. Maintenance every 2000 hours or every other yearH6.1. Clean coolant system (40)Periodically check and clean the

--- 8 6 ---H. Periodic maintenanceAH385--- Fill the system to the expansion tank fluid level mark (5).H 6.1.3. Coolant volume--- A75n, A75L 13.5 l...

--- 8 7 ---H. Periodic maintenanceAH39If the tractor is equipped with the push buttons for HiShiftas extra equipment, change the clutch fluid. The clu

--- 8 8 ---I. Checks and adjustmentsI. Checks and AdjustmentsCheck and adjustment instructions for the extraequipment are in section K, after each ext

--- 8 9 ---I. Checks and adjustmentsmaintain it correctly.IMPORTANT: The safety filter inside the main filter mustnot be cleaned but must always be ch

--- 9 0 ---I. Checks and adjustmentsI2. Electrical systemI2.1. Checking and maintenance ofbatteryA3565--- 130--- Check the charge of the battery with

--- 9 1 ---I. Checks and adjustmentsI2.4. FusesThe fuse box is placed under the instrument panel. In thecomponent list the fuses are numbered from lef

--- 6 5 ---G. Maintenance scheduleG2.2. Quality requirements of engine fuelProperty Requirement Test standardSpecific weight +15˚C, ISO 12185 0,82...0

--- 9 2 ---I. Checks and adjustmentsI 2.4.3. Other fusesIn engine bulkhead1AI10F51(F51) 15A Main current switch, electric controlled, extraequipment.

--- 9 3 ---I. Checks and adjustmentsI3. Power transmissionI3.1. Adjusting pedal free travel ofpropulsion clutch17---19 mmA3565--- 133BCACheck the peda

--- 9 4 ---I. Checks and adjustmentsI4. Brake s ystemI4.1. Adjusting travel of brake pedals65--- 93,2112443411The travel should be 60 mm with pedals c

--- 9 5 ---I. Checks and adjustments--- Depress the brake pedal fully and close the nipple andslowly let the brake pedal up again.--- Repeat the pumpi

--- 9 6 ---I. Checks and adjustmentsI 5.1.2. Adjusting toe---in 4WDA3565--- 13912Slacken the locking screw (1) of the tie rod and turn theadjusting sc

--- 9 7 ---I. Checks and adjustmentsI 6.1.1. 2WD axle380 Nm50 NmA3565--- 14121--- Raise the front end with a jack under the centre of thefront axle.--

--- 9 8 ---I. Checks and adjustmentsI6.2. Adjusting track width: Rear axle69--- 96,413.6R3616.9R30151016101710181019102010211013.6R38, 14.9R38,340/85R

--- 9 9 ---I. Checks and adjustmentsI7. If the tractor is not usedI7.1. Storing the tractorFor a period shorter than two monthsNo special measures are

--- 6 6 ---G. Maintenance scheduleG3.GreaseAlways use the following greases in Valtra tractors. Eachpoint requires it own type of grease.Valtra Grease

--- 6 7 ---G. Maintenance scheduleThe same numbering system as used on the detachedmaintenance schedule are placed in brackets whereapplicable.G4.1. D

--- 6 8 ---G. Maintenance scheduleG4.4. Every 1000 hours/yearlySee page26. Change oil and oil breather filter of the hydraulicsystem 8027. Change oil

--- 6 9 ---H. Periodic maintenanceH. Periodic maintenanceH1. GeneralPeriodic maintenance for the extra equipment are insection K, after each extra equ

--- 7 0 ---H. Periodic maintenanceH2. Maintenance daily at least every 10 hoursH2.1. Check engine oil level (1)AH1321The oil lever should come between

--- 7 1 ---H. Periodic maintenanceH3. Maintenance weekly at least every 50 hoursH3.1. Lubricatethefrontaxleandsteering nipples (3)Use Valtra Universal